Sony HDWM2000/20 Operation Manual - Page 134
Item number, Item name, Settings, 10bit, MOMNT, LATCH, MODE1, MODE2, FIELD, FRM12, FRM21
View all Sony HDWM2000/20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
10-4 Items in the Extended Setup Menu Menu items in the range 900 to 999, relating to digital processing Item number Item name Settings 901 VIDEO OUTPUT DATA Set the bit length for SD video output data. (Invalid in 24PsF or 8bit: Set the bit length to 8 bits. 23.98PsF mode) 10bit : Set the bit length to 10 bits. It is recommended that you select the optimal setting for the device to which you are going to connect this unit. 903 FREEZE MODE Select the freeze mode and timing. FIELD : Freeze a video field. Field may be odd or even, according to the timing. FLD1: Freeze an odd field. FLD2: Freeze an even field. FRM12: Freeze a frame consisting of an odd field and following even field. FRM21: Freeze a frame consisting of an even field and following odd field. Odd and even fields are distinguished by the reference video signal. Changing the menu setting during a freeze does not affect the freeze image. The setting is reflected the next time a freeze is carried out. You can freeze an image using the DELETE button and TRIM+ button. For details, see menu item 904. 904 FREEZE CONTROL Determine how the buttons used to freeze an image function. FROM KEY PANEL MOMNT : Holding the DELETE button and pressing the TRIM+ button carries out a freeze. The freeze ends when the buttons are released. LATCH: Holding the DELETE button and pressing the TRIM+ button carries out a freeze. The freeze continues even after the buttons are released. • To update the freeze image Hold the DELETE button and press the TRIM+ button again. • To end the freeze Hold the DELETE button and press the TRIM- button. 905 AUTO FREEZE CONTROL Set the auto freeze function operation (conditions for ending a freeze, etc.). In dynamic tracking playback (so-called variable speed, jog, shuttle, or normal play), if there is a sudden worsening of the channel condition (entry into unrecorded area), this function freezes the image. DIS : Disable the auto freeze function. MODE1: End the freeze when signals which can be recorded normally are restored. MODE2: End freeze automatically on playback after stopping. • The automatic freeze mode is determined by menu item 903. • The freeze is ended immediately, regardless of the above conditions, when this unit is switched to any of the following modes: EDIT preset on Cue up Recording 906 STOP FREEZE CONTROL Select whether or not the STOP FREEZE function should operate. DIS : Does not operate. ENA: Operates. stby: Operates only in the standby mode. 916 ACTIVE LINE 1035 Select the conversion mode for the number of active scan lines. CONVERT MODE (Valid only in 59.94i or 29.97PsF mode) conv : Convert the active scan lines from 1080 to 1035, without changing the aspect ratio. crop: Convert the active scan lines from 1080 to 1035. Crop the top, bottom, left, and right, then stretch the image horizontally. Note This item is valid only when menu item 018 is set to 1035. (Continued) Chapter 10 Setup Menus 10-30 Chapter 10 Setup Menus