Sony HDWM2000/20 Operation Manual - Page 148

Specifications Appendix Analog Betacam playback Video Bandwidth S/N ratio K factor (2T pulse) LF non-linearity Y/C delay Y R-Y/ B-Y Y R-Y/ B-Y Y R-Y/ B-Y Metal tape 30 Hz to 4.5 MHz +0.5 dB/ -4.0 dB 30 Hz to 1.5 MHz +0.5 dB/-3.0 dB 51 dB or more 48 dB or more 2% or less 3% or less 4% or less 20 ns or less Oxide tape 30 Hz to 4.1 MHz +0.5 dB/ -6.0 dB 30 Hz to 1.5 MHz +0.5 dB/-3.0 dB 48 dB or more 45 dB or more 3% or less Audio Metal tape LNG Frequency response (at 10 dB below reference level a)) 50 Hz to 15 kHz +1.5 dB/ -3.0 dB S/N ratio (at 3% distortion level) 72 dB or more Distortion (THD at 1 kHz reference 1% or less level a)) Wow and flutter 0.1% rms or less AFM Frequency response (at reference 20 Hz to 20 kHz +0.5 dB/-2.0 dB level a)) S/N ratio (at 3% distortion level) 85 dB or more Distortion (THD at 1 kHz reference 0.5% or less level a)) a) Reference level: +4 dBm Oxide tape 50 Hz to 15 kHz +3.0 dB 50 dB or more (Dolby NR off) 2% or less 0.1% rms or less - - - Processor adjustment range Video level ±3 dB/ -∞ to +3 dB selectable Chroma level ±3 dB/ -∞ to +3 dB selectable Setup level (59.94i, 29.97PsF mode) ±30 IRE Black level (50i, 25PsF mode) ±210 mV Chroma phase ±30° System phase Sync: ±15 µs SC: ±200 ns Input connectors HDSDI INPUT SDTI INPUT BNC (1 each for input and for through output to a monitor) Serial digital (1.485 Gbits/s) SMPTE 292M BNC (1) (optional) SMPTE 305M (SDTI) REF. VIDEO INPUT BNC (2 in loop through connection) Black burst or composite sync 0.3 Vp-p, 75 Ω, sync negative AUDIO INPUT CH1/2/3/4 XLR 3-pin, female (4) LOW OFF: -60 dBu, high impedance, balanced HIGH OFF: +4 dBu, high impedance, balanced HIGH ON: +4 dBm, 600 Ω termination, balanced CUE IN XLR 3-pin, female (1) LOW OFF: -60 dBu, high impedance, balanced HIGH OFF: +4 dBu, high impedance, balanced HIGH ON: +4 dBm, 600 Ω termination, balanced A-4 Appendix