Xerox 2006NPC DocuColor 2006 User Guide - Page 23
Setting up the DocuColor 2006, Preparing for the installation, Selecting a location
UPC - 042215475440
View all Xerox 2006NPC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
1 Setting up the DocuColor 2006 This chapter contains the hardware installation instructions only. To install the printer driver software, go to the Installing your user software chapter. To install to the network, go to the appropriate chapter for your operating system. Preparing for the installation Before you begin the installation of your Xerox DocuColor 2006, read this entire section. You must locate an appropriate site for the installation of the DocuColor 2006. Reading this section assists you with the decision making process. Selecting a location WARNING The wall outlet must be rated for 115 or 240 volts. It must also be protected for at least 15 amps for 115 volts, or 8 amps for 240 volts. If you are in doubt about a power source, ensure that a qualified electrician checks the outlet. Do not connect any other devices to the wall outlet designated for the Xerox DocuColor 2006. Install the Xerox DocuColor 2006 in a location that meets the following conditions: • The DocuColor 2006 has a designated wall outlet. • The power cord cannot be stepped on, or be a tripping hazard. • The location has a level, stable surface. DO NOT install the DocuColor 2006 in a location that has any of the following conditions: • In direct sun light • Near an air conditioner or heater • In a dusty place • Near an open flame • In a windy place • Near water • Where it might be subject to • Near a magnetic field vibration • Where abrupt changes in temperature or humidity occur Xerox DocuColor 2006 1-1