Xerox 2006NPC DocuColor 2006 User Guide - Page 492

24. Problem Solving Network Problem Solving Network Protocol Setup messages The following table lists the network protocol messages that you may see during the Network Protocol setup. It also contains the last Setup screen shown before the message appeared, a description of the problem, and any action required. Message No AppleTalk zone found. You must first enable a network port. Invalid frame size Warning IPX network number is zero. Can't detect Token Ring hardware. 24-44 Setup screen Enable AppleTalk (Network Protocol Setup> AppleTalk Setup) Protocol Setup or Service Setup (Network Setup) Frame Type selection (Network Protocol Setup> IPX>SPX Setup) Frame Type selection (Network Protocol Setup> IPX>SPX Setup) Frame Type selection (Network Protocol Description and action • The Ethernet network cable is not attached to the connector on the DocuColor 2006 or the network cable is not plugged into the hub or network. If your AppleTalk network has zones, and you want to specify a zone for the Printer, you must connect the network cable to the DocuColor 2006 before performing AppleTalk Setup. • AppleTalk network does not have zones. Zones are not required for printing to the DocuColor 2006. Press OK to continue. Enable at least one network port (Ethernet or Token Ring) in Port Setup before beginning Protocol Setup or Service Setup. The network hub is not connected to a Novell server when the DocuColor 2006 tries to bind. No other IPX computer can be found on the network, or the network hub is not connected to the network when the DocuColor 2006 tries to bind. When this occurs, the network number defaults to zero. The Printer queries the Token Ring hardware. Either some Xerox DocuColor 2006