Xerox 2006NPC DocuColor 2006 User Guide - Page 376

20. Using ColorWise Pro Tools Checking Calibration Status You can check whether the Fiery is calibrated, which calibration set and output profile were used, and when the copier was last calibrated: • Print a Configuration page or Test Page from the Control Panel. • When you select a calibration set in Calibrator, the last calibration and the user who performed it are displayed. Using a Densitometer ColorWise Pro Tools are designed to work with the X-Rite DTP32 reflection densitometer where color measurements are entered automatically. Setting up the Densitometer Before you calibrate the Fiery, you need to connect, configure, and calibrate the densitometer to prepare for measuring the printed patches. For additional information about setting up and using the densitometer see the documentation included with it. To Connect the X-Rite DTP32 to the Computer 1. Turn off the computer. 2. Plug the square end of the interface cable (looks like a modular phone plug) into the I/O port on the side of the X-Rite DTP32. 3. Attach the connector to the computer. For a Windows computer, insert the 8-pin mini-DIN end of the interface cable into the 9-pin DB9 Connector cable adapter. Insert the 9-pin end into the COM1 or COM2 port on the computer and tighten the screws. If the available port on your computer is 25-pin, you must use the 8-pin to 25-pin adapter. For a Mac OS computer, connect the 8-pin mini-DIN plug directly into the serial port of the computer. For Macintosh computers with a USB port, you need an adapter to connect the DTP32 to your computer. See the X-Rite, Inc. web site at www.x-rite.com for information on supported adapters. 4. Use the AC adapter to provide power. Plug the small connector on the adapter cable into the side of the X-Rite DTP32 and plug the adapter into a wall outlet. 5. Turn on the computer 6. Calibrate the densitometer. 7. Use ColorWise Pro Tools to calibrate the Fiery. 20-4 Xerox DocuColor 2006