Xerox 8560MFP System Administrator Guide - Page 56
Fax Send Setup, Auto Resend Count
UPC - 095205428841
View all Xerox 8560MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Fax Defaults ■ 14.4 kbps (G3) ■ 19.2 kbps ■ 28.8 kbps ■ 33.6 kbps (Super G3) Error Correction Mode: This setting turns Off or On automatic error correction during fax transmission and reception. The default setting is On. Fax Send Setup Transmission Report: This setting specifies when a fax Transmission Report is printed. Transmission Reports provide feedback about the fax transmission, such as when it was sent, call duration, etc. The default setting is Error Only. ■ Always: A Transmission Report is printed for each fax sent. ■ Never: A Transmission Report is not printed for any fax sent. ■ Error Only: A Transmission Report is only printed when a fax error occurs for one or more recipients. Note: You can override this setting at the control panel. Report with reduced 1st page: This setting turns On or Off printing a reduced image of the first faxed page on the Transmission Report. The default setting is On. Redial Count: This setting determines the number of redial attempts the system makes after encountering a busy signal. The default setting is 3 Times. Redial Time Interval: This setting specifies how many minutes the system waits to redial after encountering a busy signal. The default setting is 3 Minutes. Auto Resend Policy: This setting specifies what the system does with fax pages after an interruption. The default setting is Unsent pages. ■ Unsent pages: Send pages that were not sent. ■ All pages: Resend all pages. Auto Resend Count: This setting specifies the number of times to restart a fax transmission after an interruption. The default setting is 3 Times. Resolution: This setting determines the fax print resolution. The default setting is Fine (200 x 200). The following values are supported: ■ Standard (200 x 100) ■ Fine (200 x 200) ■ Super Fine (200 x 400) Transmission Header: This setting turns Off or On including the Line Name in the Transmission Header. The default setting is On. System Administrator Guide 6-3