Yamaha RX-V2500 Owner's Manual - Page 27
Connecting the antennas, ohm/300-ohm antenna adapter, U.K. model only - 4 ohm
View all Yamaha RX-V2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
PREPARATION Connecting the antennas Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals. AM loop antenna Indoor FM antenna (included) (included) CONNECTIONS 3 Orient the AM loop antenna for the best reception. TUNER FM ANT 75Ω UNBAL. GND AM ANT COMPONENT VIDEO Y PB PR DVD DTV CBL/ SAT MONITOR OUT Ground (GND terminal) For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. ■ Connecting the AM loop antenna 1 Set up the AM loop antenna, then connect it to the terminals on this unit. Notes • The AM loop antenna should be placed away from this unit. • The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit. • A property installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas. ■ 75-ohm/300-ohm antenna adapter (U.K. model only) 1 Open the cover of the included 75-ohm/300-ohm antenna adapter. 2 Cut the external sleeve of the 75-ohm coaxial 11 (7/16) 8 (5/16) cable and prepare it for 6 (1/14) connection. Unit: mm (in) 3 Cut the lead wire and remove it. Lead wire 2 Press and hold the tab to insert the AM loop antenna lead wires into the AM ANT and GND terminals. 4 Insert the cable wire into the slot, and clamp it with pliers. Clamp Insert the wire into the slot 5 Snap the cover into place. Clamp 23