Yamaha RX-V2500 Owner's Manual - Page 29

PREPARATION Speaker impedance setting Be sure this unit is in the standby mode. 1 On the front panel, while holding down STRAIGHT/EFFECT, press STANDBY/ON. "SP IMP.-8ΩMIN" appears on the front panel display. STRAIGHT EFFECT STANDBY /ON CONNECTIONS Turning on the power When all connections are complete, turn on the power of this unit. 1 STANDBY /ON INPUT PURE DIRECT VOLUME SPEAKERS A B MULTI CH INPUT MODE INPUT SOURCE /REMOTE DVD MD/TAPE D-TV CD-R A/B/C/D/E CBL/SAT TUNER VCR 1 CD DVR /VCR2 REC OUT /ZONE 2 OPTIMIZER MIC PRESET/ TUNING PRESET TUNING /TUNING FM/AM MEMORY MODE ZONE ON/OFF MAIN ZONE 2 YPAO EDIT MAN'L/AUTO FM AUTO/MAN'L MONO SILENT CINEMA S VIDEO VIDEO L AUDIO R PHONES VIDEO AUX OPTICAL PROGRAM TONE CONTROL STRAIGHT EFFECT SP IMP.-8 MIN 2 Press STRAIGHT/EFFECT to select the impedance of your speakers. You can select either 6 ohms or 8 ohms. 3 Press STANDBY/ON to exit the setting. This unit will be set to the standby mode. Note Speaker impedance setting function is located in the Advanced menu (see page 81). CAUTION If you are using 6 ohm speakers, set the impedance to 6 ohms before turning on the power. (U.S.A. model) POWER TV POWER AV STANDBY SYSTEM POWER A B INPUT MODE SLEEP PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD 1 ++ SELECT AMP + 1 Press STANDBY/ON (SYSTEM POWER on the remote controls) to turn on the power of this unit. SYSTEM POWER STANDBY /ON or Front panel Remote control 2 Turn on the video monitor connected to this unit. Note Press STANDBY/ON again (STANDBY on the remote control) to enter the standby mode. 25