Yamaha RX-V2500 Owner's Manual - Page 73
Programming codes from other remote controls (Learn), Set AMP/SOURCE/TV to SOURCE.
View all Yamaha RX-V2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
REMOTE CONTROL FEATURES 6 Press ENTER to set the number. "OK" appears in the display window if setting was successful. "NG" appears in the display window if the setting was unsuccessful. In this case, start over from step 3. y If you continuously want to set up another code for another component, press the input selector button or SELECT k/n to select the component, then repeat steps 4 through 6. 7 Press LEARN again to exit from the setup mode. LEARN 8 Press one of the buttons shaded below to see if you can control your component. If you can, the remote control code is correct. POWER TV TRANSMIT POWER AV STANDBY SYSTEM POWER A B INPUT MODE SLEEP PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD FREQ/RDS EON MODE PTY SEEK START REC DISC SKIP OFF ON MACRO LEARN CLEAR RE-NAME y If the manufacturer of your component has more than one code, try each of them until you find the correct one. Notes • "ERROR" appears in the display window if you press a button not indicated in the respective step, or when you press more than one button simultaneously. • The supplied remote control does not contain all possible codes for commercially available audio and video components (including YAMAHA components). If operation is not possible with any of the remote control codes, program the new remote control function using the Learn feature (see "Programming codes from other remote controls (Learn)") or use the remote control supplied with the component. • Function programmed using the learn feature take priority over remote control code functions. SELECT VCR 1 DVR/VCR2 DVD DTV CD-R V-AUX CBL/SAT MD/TAPE MULTI CH IN CD PHONO TUNER INPUT MODE SLEEP B A POWER AV POWER TV SYSTEM POWER STANDBY TRANSMIT Programming codes from other remote controls (Learn) Use the Learn feature if you want to program functions not included in the basic operations covered by remote control codes, or an appropriate remote control code is not available. You can program any of the buttons available in the component control area (see page 66). The buttons can be programmed independently for each component. Note This remote control transmits infrared beams. If the other remote control also uses infrared beams, this remote control can learn most of its functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operating instructions for the other remote control.) 1 Set AMP/SOURCE/TV to SOURCE. AMP SOURCE TV 2 Press an input selector button to select a source component. A B INPUT MODE SLEEP PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD 3 Place this remote control about 5 to 10 cm (2 to 4 in) apart from the other remote control on a flat surface so that their infrared transmitters are aimed at each other. 5 to 10 cm (2 to 4 in) ADVANCED OPERATION 69