2012 Nissan Quest Owner's Manual - Page 107
2012 Nissan Quest Manual
Page 107 highlights
about 30 seconds the vehicle security system automatically shifts into the armed phase. The security light begins to flash once every approximately 3 seconds. If, during this 30-second pre-arm time period, the door is unlocked, or the ignition switch is pushed to ACC or ON, the system will not arm. Even when the driver and/or passengers are in the vehicle, the system will activate with all doors and lift gate locked with the ignition switch in the LOCK position. When pushing the ignition switch to the ACC or ON position, the system will be released. by releasing the door inside lock knob, the alarm will activate.) How to stop an activated alarm GUID-05DDA89B-F7D9-4C65-A192-A1CBC7D96A4F The alarm will stop by unlocking a door by pushing the unlock button on the Intelligent Key, the door handle request switch or using the mechanical key. The alarm will not stop if the ignition switch is pushed to the ACC or ON position. If the system does not operate as described above, have it checked by a NISSAN dealer. SIC2045 How to arm GUID-8D123C36-E9F9-4871-811D-D6C0C142AF46 the vehicle security system 1. Close all windows. The system can be armed even if the windows are open. 2. Push the ignition switch to the OFF position. 3. Remove the Intelligent Key from the vehicle. 4. Close all doors and lift gate. Lock all doors. The doors can be locked with the Intelligent Key, door handle request switch, power door lock switch or mechanical key. 5. Confirm that the security indicator light comes on. The security indicator light stays on for about 30 seconds. The vehicle security system is now pre-armed. After Vehicle security system activation GUID-BB38DE0B-6ADD-44EA-821D-7DC2AE8F4E1E The vehicle security system will give the following alarm: . The headlights blink and the horn sounds intermittently. . The alarm automatically turns off after approximately 1 minute. However, the alarm reactivates if the vehicle is tampered with again. The alarm is activated by: . Unlocking the door or opening the lift gate without using the button on the Intelligent Key, the door handle request switch or the mechanical key. (Even if the door is opened NISSAN VEHICLE IMMOBILIZER SYSTEM GUID-3F81F329-63EA-4A18-A472-E8D6E2A9B23A The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of the registered Intelligent Key. Never leave these keys in the vehicle. For USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2-28 Instruments and controls