2012 Nissan Quest Owner's Manual - Page 178

AUTOMATIC DRIVE POSITIONER (if so equipped) GUID-D7276E5F-FB84-463B-BDF9-A346295A447B The automatic drive positioner system has two features: . . Entry/exit function Memory storage ENTRY/EXITGUID-5F29AE45-A8DA-42BF-A7C8-04256D167074 FUNCTION This system is designed so that the driver's seat will automatically move when the selector lever is in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward when the driver's door is opened with the ignition switch in the LOCK position. The driver's seat will return to the previous positions when the ignition switch is pushed to the ACC position. The driver's seat will not return to the previous positions if the seat adjusting switch is operated when the seat is at the exit position. and 2) will blink once when the function is canceled, and the indicator lights will blink twice when the function is activated. Note that the indicator lights may illuminate after 5 seconds while holding the SET switch. This indicates readiness for linking the Intelligent Key to a stored memory position. Keep the SET switch pressed for more than 10 seconds to turn on or off the entry/exit function. The entry/exit function can also be activated or canceled if the "Slide Driver Seat Back on Exit" key is turned to ON or OFF in the "Comfort" settings. (See "Vehicle information and settings (models with center multi-function control panel)" (P.4-9).) SPA2855 MEMORY STORAGE GUID-BEDCA7A8-8409-4EC2-8EAE-7F30A20C2AA8 Two positions for the driver's seat and outside mirrors can be stored in the automatic drive positioner memory. Follow this procedure to use the memory system. 1. Move the selector lever to the P (Park) position. 2. Push the ignition switch to the ON position. 3. Adjust the driver's seat and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see "Seats" (P.1-2) and "Outside mirrors" (P.3-35). Initialize entry/exit function GUID-E526DD89-2FEC-4DC6-8386-CED70B431AFF If the battery cable is disconnected, or if the fuse opens, the entry/exit function will not work though this function was set on before. In such a case, after connecting the battery or replacing with a new fuse, open and close the driver's door more than two times after the ignition switch is placed in the LOCK position from the ON position. The entry/exit function will be activated. Cancel or activate entry/exit function GUID-97B13C13-98B1-43DA-BF4E-6CC11E5EE734 The selector lever must be in the P (Park) position with the ignition switch in the OFF position. The entry/exit function can be activated or canceled by pressing and holding the SET switch for more than 10 seconds. The indicator lights on the memory switches (1 Pre-driving checks and adjustments 3-37