2012 Nissan Quest Owner's Manual - Page 221
2012 Nissan Quest Manual
Page 221 highlights
. Pushing the "DUAL" button allows the user to independently change the front passenger's side temperature with the passenger side temperature control buttons (" " or " "). ("DUAL" will appear on the display.) To cancel the separate temperature setting, push the "DUAL" button ("DUAL" will disappear from the display) and the driver's side temperature setting will be applied to both the driver's and front passenger's sides. culation and outside air circulation modes. (The " " or " " indicator light will blink twice.) The following conditions need to be met for the automatic air intake control mode to function properly. . The air flow control is not in the front defroster mode (the indicator light on the front defroster " FRONT" button is turned off). The outside temperature is approximately 328F (08C) or above. . . their maximum position. After the windshield is cleared, push the "AUTO" button to set to the automatic mode. When the front defroster " FRONT" button is pushed, the air conditioner will automatically turn on sensing the outside air temperature to defog the windshield. Do not select the air recirculation mode for the best defogging performance. 4. Models with Advanced Climate Control System (ACCS): . Push the " AUTO" auto-recirculation button. The indicator light on the " AUTO" auto-recirculation button will illuminate. In this mode, the sensor detects odors and gas to automatically switch between the air recirculation mode and the outside air circulation mode. (See "Advanced climate control system" (P.442) for details.) Models without Advanced Climate Control System (ACCS): . Push and hold the air recirculation " " button or outside air circulation " " button (the one with the indicator light on) for more than 2 seconds to set the automatic control between the air recir- . NOTE: Do not set the temperature too low when the front defroster mode is on (the indicator on the front defroster " FRONT" button is illuminated). Doing so may fog up the windshield. NOTE: . Do not set the temperature lower than the outside air temperature. Doing so may prevent the temperature from being controlled properly. . To dehumidify the air, push the "A/C" button before turning on the heater. Dehumidified defrosting/defogging: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 1. Push the front defroster " FRONT" button. (The indicator light will illuminate.) 2. Push the temperature control buttons (" " and " ") to set the desired temperature. . To remove frost from the outside surface of the windshield quickly, set the temperature control and fan speed control to Manual operation GUID-5BB422CA-6F6D-4204-8723-4A4B9231097D The manual mode can be used to control the heater and air conditioner to your desired settings. Fan speed control: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Push the fan speed control button " " to increase the fan speed. Push the fan speed control button " decrease the fan speed. " to Push the "AUTO" button to change the fan speed to the automatic mode. 4-40 Monitor, heater, air conditioner, audio, phone and voice recognition systems