2012 Nissan Quest Owner's Manual - Page 364
2012 Nissan Quest Manual
Page 364 highlights
BSW temporarily not available GUID-6D4D6EF8-1DF9-4D89-8011-E54A25724E70 . When radar blockage is detected, the BSW system will be turned off automatically, a beep will sound and the BSW system warning light will blink. The BSW system is not available until the condition no longer exists. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such as ice, frost or dirt obstructing the radar sensors. SSD1038 Action to take: When the above condition no longer exists, the BSW system will resume automatically. If the warning light continues to blink, have the BSW system checked by a NISSAN dealer. SSD1178 If the driver activates the turn signal, then the BSW indicator light flashes and a chime will sound twice. NOTE: If the driver activates the turn signal before a vehicle enters the detection zone, the BSW indicator light will flash but no chime will sound when another vehicle is detected. BSW MALFUNCTION GUID-1F7A26C5-A202-469B-81D0-8B3F6C47D612 When the BSW system malfunctions, they will be turned off automatically, a beep will sound and the BSW system warning light will illuminate. Action to take: Stop the vehicle in a safe location, turn the engine off and restart the engine. If the warning light continues to illuminate, have the BSW system checked by a NISSAN dealer. A for the BSW The two radar sensor units * system are located near the rear bumper. Always keep the area near the radar sensors clean. Do not attach stickers (including transparent material), install accessories or apply additional paint near the radar sensors. Do not strike or damage the area around the radar sensors. Consult a NISSAN dealer if the area around the radar sensors is damaged due to a collision. SYSTEM MAINTENANCE GUID-CBDF7C40-05E0-4E96-BAE0-D10F27EC5605 Starting and driving 5-23