2012 Nissan Quest Owner's Manual - Page 305
2012 Nissan Quest Manual
Page 305 highlights
. . . . - Your vehicle is outside of the telephone service area. - Your vehicle is in an area where it is difficult to receive radio waves; such as in a tunnel, in an underground parking garage, near a tall building or in a mountainous area. - Your cellular phone is locked to prevent it from being dialed. When the radio wave condition is not ideal or ambient sound is too loud, it may be difficult to hear the other person's voice during a call. Immediately after the ignition switch is pushed to the ON position, it may be impossible to receive a call for a short period of time. Do not place the cellular phone in an area surrounded by metal or far away from the invehicle phone module to prevent tone quality degradation and wireless connection disruption. While a cellular phone is connected through the Bluetooth® wireless connection, the battery power of the cellular phone may discharge quicker than usual. The Bluetooth® Hands-Free Phone System cannot charge cellular phones. . . . . If the Bluetooth® Hands-Free Phone System seems to be malfunctioning, see "Troubleshooting guide" later in this section. You can also visit www.nissanusa.com/bluetooth for troubleshooting help. Some cellular phones or other devices may cause interference or a buzzing noise to come from the audio system speakers. Storing the device in a different location may reduce or eliminate the noise. Refer to the cellular phone Owner's Manual regarding battery charging, cellular phone antenna, etc. This wireless hands free car kit is based on Bluetooth® technology, - Frequency: 2402 MHz - 2480 MHz - Output Power: 4.14 dBm E.I.R.P - Modulation: FHSS GFSK 8DPSK, p/ 4DQPSK - Number of Channels: 79 - This wireless equipment can't be used for any services related to safety because there is the possibility of radio interference. REGULATORY INFORMATION GUID-A460D0D9-8490-43FD-B196-3549133FC984 FCC Regulatory information GUID-1004B2AB-B6EF-4D5E-AA6F-295F6B4E7FCB . CAUTION: To maintain compliance with FCC's RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus meets all requirements of the Canadian InterferenceCausing Equipment Regulations. . IC Regulatory information GUID-7756FBD9-E590-428A-83DB-72F994B08146 . . 4-124 Monitor, heater, air conditioner, audio, phone and voice recognition systems