2012 Nissan Quest Owner's Manual - Page 179
2012 Nissan Quest Manual
Page 179 highlights
4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2). The indicator light for the pushed memory switch will stay on for approximately 5 seconds after pushing the switch. If memory is stored in the same memory switch, the previous memory will be deleted. Confirming memory storage GUID-C7D22E67-E6D7-436F-A7E9-FBD8970F3E83 . Push the ignition switch to the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 second. When the memory has stored in position, the indicator light will stay on for approximately 5 seconds. If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. In this case, reset the desired position using the previous procedure. If optional keys are added to your vehicle, the memory storage procedure to switch 1 or 2 and linking Intelligent Key procedure to a stored memory position should be performed again for each Intelligent Key. For additional Intelligent Key information, see "Keys" (P.3-3). . Within 45 seconds of opening the driver's door, push the memory switch (1 or 2). The driver's seat and outside mirrors will move to the memorized position with the indicator light flashing, and then the light will stay on for approximately 5 seconds. Linking Intelligent Key to a stored memory position GUID-04712762-5C07-46C9-89DF-7F2803A498EB The Intelligent Key can be linked to a stored memory position with the following procedure. 1. Follow one of the steps for storing a memory position. While the indicator light for the memory switch being set is illuminated for 5 seconds, push the button on the Intelligent Key. . Push the ignition switch to the OFF position, and then push the SET switch. Push the button while pushing the memory button while the indicator light stays on for approximately 5 seconds. If the indicator light blinks, the Intelligent Key is linked to that memory setting. Push the ignition switch to the OFF position, and then push the button on the Intelligent Key. The driver's seat and outside mirrors will move to the memorized position. . . SYSTEM OPERATION GUID-B0CC6635-8934-4D55-BA9A-D54FF3D35461 The automatic drive positioner system will not work or will stop operating under the following conditions: ...When the vehicle speed is above 4 MPH (7 km/h) (entry/exit function). When the vehicle is driven (memory storage). When the adjusting switch for the driver's seat is turned on while the automatic drive positioner is operating. When the driver's seat and outside mirrors have already been moved to the memorized position. When no position is stored in the memory switch. When the engine is started while moving the automatic drive positioner. When the selector lever is moved from the P (Park) position to any other position. (However, it will not be canceled while the driver's . Selecting the GUID-66874194-881E-4A22-96FF-EE790B2F0E22 memorized position 1. Move the selector lever to the P (Park) position. 2. Use one of the following methods to move the driver's seat and outside mirrors. . Push the ignition switch to the ON position and push the memory switch (1 or 2). . ... 3-38 Pre-driving checks and adjustments