2012 Nissan Quest Owner's Manual - Page 134
2012 Nissan Quest Manual
Page 134 highlights
Tilting GUID-71C9D819-F26A-4EE7-848B-DF749AB96C52 To tilt up, first close the moonroof, then push the B and release it; it switch to the tilt up position * does not need to be held. To tilt down the moonroof, push the switch to the tilt down A . position * the moonroof is closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is pushed to the OFF position. If the moonroof cannot be closed automatically when the auto reverse function activates due to a malfunction, push and hold the moonroof B . switch to the close position * Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs. 3. Release the moonroof switch, then continue B side again. The moonroof to push on the * will operate in the close direction. (The moonroof operates inch by inch.) 4. After the moonroof stops moving, release the moonroof switch and within 4 seconds, B push side * again. The moonroof will automatically open once. 5. Within 0.5 seconds after the moonroof stops moving, release the moonroof switch. 6. Check that the moonroof now operates normally. If the moonroof does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer. Locking GUID-2B4725F8-8023-4BBB-9A25-2063EA7D24B0 When the window lock button is pushed in, the rear moonroof cannot be operated. When the window lock position is pushed off, the rear moonroof can be operated. (See "Power windows" (P.2-51).) Auto-reverseGUID-42AC8800-B709-488D-ADE1-B48120CFF197 function IF THE FRONT OR REAR MOONROOF DOES NOT GUID-837D8DA1-D393-41F7-9FCA-B31DD791AD27 OPERATE If the front or rear moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system. Initialization can be performed for both the front moonroof and rear moonroof. 1. If the moonroof is open, close it fully by pushing and holding the moonroof switch to B until the moonroof the close position * tilts up. 2. Release the moonroof switch, then push and B side again for more than 10 hold the * seconds. WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof. If the control unit detects something caught in the moonroof when it is closing, the moonroof will be immediately opened. The auto reverse function can be activated when Instruments and controls 2-55