2012 Nissan Quest Owner's Manual - Page 116

HAZARD WARNING FLASHER SWITCH GUID-3178C863-2DA0-4F82-821B-131FBEE8BA99 SIC3671 SIC3672 SIC2574 TURN SIGNAL SWITCH GUID-5783ED17-A386-4FAB-974F-C071ADBFA146 1 Turn signal * GUID-AC2E834A-6733-443E-8A5A-3FA51FB86FC9 FOG LIGHTGUID-3FD59AE7-AF99-47FD-9F2C-FC49B3C023B2 SWITCH (if so equipped) To turn the fog lights on, turn the headlight switch to the position, then turn the switch to the position. To turn them off, turn the switch to the OFF position. The headlights must be on for the fog lights to operate. When the headlight switch is in the AUTO position (if so equipped): . Turning the fog light switch to the position will turn on the headlights, fog lights and the other lights while the ignition switch is in the ON position or the engine is running. Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights will flash. Move the lever up or down to signal the turning direction. When the turn is completed, the turn signals cancel automatically. 2 Lane change signal * GUID-5C53C7BE-DDE1-434D-B0DB-47BE677A5D27 WARNING . If stopping for an emergency, be sure to move the vehicle well off the road. Do not use the hazard warning flashers while moving on the highway unless unusual circumstances force you to drive so slowly that your vehicle might become a hazard to other traffic. Instruments and controls 2-37 To indicate a lane change, move the lever up or down to the point where lights begin flashing. .