2012 Nissan Quest Owner's Manual - Page 222

Air flow control: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Push the "MODE" button to change the air flow mode. : : : : Air flows from the center and side ventilators. Air flows from the center and side ventilators, and foot outlets. Air flows mainly from the foot outlets. Air flows from the defroster and foot outlets. . compartment. The indicator light on the air recirculation " " button will turn off. Models without Advanced Climate Control System (ACCS): Push the outside air circulation " " button to draw outside air into the passenger compartment. The indicator light on the outside air circulation " " button will turn on. The following conditions need to be met for the automatic air intake control mode to function properly. . The air flow control is not in the front defroster mode (the indicator light on the front defroster " FRONT" button is turned off). The outside temperature is approximately 08C (328F) or above. . Temperature control: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Push the temperature control buttons (" " and " ") to set the desired temperature. The temperature can be set within the range of 60 to 908F (18 to 328C). Air recirculation: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Push the air recirculation " " button to recirculate interior air inside the vehicle. The indicator light on the air recirculation " " button will illuminate. The air recirculation mode cannot be activated when the air conditioner is in the front defrosting mode. Outside air circulation: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 . Models with Advanced Climate Control System (ACCS): Push the air recirculation " " button twice to draw outside air into the passenger Automatic air GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 intake control: . Models with Advanced Climate Control System (ACCS): Push the " AUTO" auto-recirculation" button to switch to the automatic air intake control mode. The indicator light on the " AUTO" auto-recirculation button will illuminate. In this mode, the sensor detects odors and gas to automatically switch between the air recirculation mode and the outside air circulation mode. (See for details.) . Models without Advanced Climate Control System (ACCS): To switch to the automatic control mode, push the intake air control button for about 2 seconds. The indicator lights (both air recirculation " " and outside air circulation " " buttons) will flash twice, and then the intake air will be controlled automatically. Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-41