2012 Subaru Legacy Owner's Manual - Page 234

3-16 Instruments and controls ally reducing speed. Then slowly pull off the road to a safe place. Otherwise an accident involving serious vehicle damage and serious personal injury could occur. If this light still illuminates while driving after adjusting the tire pressure, a tire may have significant damage and a fast leak that causes the tire to lose air rapidly. If you have a flat tire, replace it with a spare tire as soon as possible. When a spare tire is mounted or a wheel rim is replaced without the original pressure sensor/transmitter being transferred, the Low tire pressure warning light will illuminate steadily after blinking for approximately one minute. This indicates the TPMS is unable to monitor all four road wheels. Contact your SUBARU dealer as soon as possible for tire and sensor replacement and/ or system resetting. If the light illuminates steadily after blinking for approximately one minute, promptly contact a SUBARU dealer to have the system inspected. CAUTION The tire pressure monitoring system is NOT a substitute for manually checking tire pressure. The tire pressure should be checked periodically (at least monthly) using a tire gauge. After any change to tire pressure(s), the tire pressure monitoring system will not re-check tire inflation pressures until the vehicle is first driven more than 20 mph (32 km/h). After adjusting the tire pressures, increase the vehicle speed to at least 20 mph (32 km/h) to start the TPMS re-checking of the tire inflation pressures. If the tire pressures are now above the severe low pressure threshold, the low tire pressure warning light should turn off a few minutes later. Therefore, be sure to install the specified size for the front and rear tires. & ABS warning light CAUTION . If any of the following conditions occur, we recommend that you have the ABS system repaired at the first available opportunity by your SUBARU dealer. - The warning light does not illuminate when the ignition switch is turned to the "ON" position. - The warning light illuminates when the ignition switch is turned to the "ON" position, but it does not turn off even when the vehicle speed exceeds approximately 12 km/h (8 mph). - The warning light illuminates during driving. - The warning light flashes. . When the warning light is on (and brake system warning light is off), the ABS function shuts down; however, the conventional brake system continues to operate normally. . When the warning light is flashing, the ABS system may be malfunctioning. However, the conventional brake system continues to operate normally. The ABS warning light illuminates together with the brake system warning light if the EBD system malfunctions. For further details of the EBD system mal-