2012 Subaru Legacy Owner's Manual - Page 304
2012 Subaru Legacy Manual
Page 304 highlights
5-22 Audio ! Category selection (type C audio) Change the category up by one step Change the category down by one step Press the "SCAN/A.S" button again to cancel the SCAN mode and to stop on any displayed channel. ! Selecting preset channels 1. Press the "SAT" button to select SAT1, SAT2 or SAT3 reception. 2. Press the preferred preset button (from to ) briefly. & Channel preset ! How to preset channels 1. Press the "SAT" button to select SAT1, SAT2 and SAT3 reception. 2. Select the desired channel. 3. Press and hold one of the preset buttons (from to ) to store the channel. If the button is pressed briefly, the preceding selection will remain in the memory. To activate the category search mode, press the " " or " " button. When in the category search mode, press the " " or " " button to change the category up or down. When a category is selected, turning the "TUNE" dial selects channels only within the selected category. The control function returns to the normal mode after approximately 6 seconds. ! Channel scan (type C audio) "SCAN/A.S" button & When the following messages are displayed (type C audio) If one of the following messages is displayed when receiving XM signals, determine the cause based on the following information. If you cannot clear these messages, contact your SUBARU dealer. NOTE . Up to six SAT1, SAT2 and SAT3 channels each may be preset. . If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset channels. Press the "SCAN/A.S" button to change the radio to the SCAN mode. In this mode, under the selected category, the radio scans through the channel until a station is found. The radio will stop at the station for 5 seconds while displaying the channel number, after which scanning will continue until the entire channel has been scanned.