2012 Subaru Legacy Owner's Manual - Page 388
2012 Subaru Legacy Manual
Page 388 highlights
7-12 Starting and operating remote keyless entry transmitter will disarm the alarm system. Refer to "Alarm system" F2-15. 2. Enter the vehicle. 3. The engine will shut down when any door or trunk/rear gate is opened. 4. Insert the key into the ignition switch and turn to the "START" position to restart the engine. Transmitter flash sequence Flashes when button is pressed Two long flashes following remote start activation (transmitter button is pressed two times within 3 seconds) One flash following remote start activation (transmitter button is pressed two times within 3 seconds) 2 flashes every 5 seconds Feature description Indicates that the system is transmitting an RF signal. Indicates that the transmitter did not receive the remote start activation confirmation from the vehicle system. The transmitter will automatically send one additional remote start activation attempt. This usually occurs when the operational range is at its limit or has been exceeded. Indicates that the engine is running via remote start. If the transmitter is moved outside of the operating range of the system, this sequence will timeout after the normal 15-minute vehicle run cycle. Indicates that the engine is running via remote start. If the transmitter is removed outside of the operating range of the system, this sequence will timeout after the normal 15-minute vehicle run cycle. Indicates that the engine has turned off due to a remote start system 15-minute timeout, vehicle safety parameter or normal shutdown. & Remote start confirmation transmitter feature Your remote engine start transmitter is equipped with a unique bidirectional confirmation feature. This feature will allow the transmitter 's backlit button to display the status of the system under the condition that the vehicle and transmitter are within the operational range of the system. Typical transmitter button flash sequences are outlined in the following chart. 3 flashes