2012 Subaru Legacy Owner's Manual - Page 258
2012 Subaru Legacy Manual
Page 258 highlights
3-40 Instruments and controls website at www.homelink.com or call 1-800-355-3515. park the vehicle outside the garage. 1. Unplug the motor of the garage door opener from the outlet. CAUTION When programming the HomeLink® Wireless Control System to operate a garage door opener or an entrance gate, unplug the device's motor from the outlet during programming to prevent motor burnout. NOTE If any of the HomeLink® buttons are already programmed for other devices, skip step 2 because it clears the memory of all three buttons. NOTE . After programming your HomeLink® Wireless Control System for the desired devices, retain the hand-held transmitters for further programming or device testing in the event of a problem. . It is recommended that you insert a new battery in the hand-held transmitter of a device to ensure correct programming. ! Garage door opener programming in the U.S.A. 1) 2) 3) HomeLink® button 1 HomeLink® button 2 HomeLink® button 3 NOTE When programming the HomeLink® Wireless Control System for a garage door opener, it is suggested that you 2. Press and hold the two outer HomeLink® buttons (button 1 and button 3) until the indicator light begins to flash (after approximately 20 seconds). Then release both buttons. 3. Hold the end of the garage door opener 's hand-held transmitter between 1 and 3 inches (25 and 76 mm) away from the HomeLink® button you wish to program. 4. Simultaneously press and hold both the hand-held transmitter button and the desired HomeLink® button. DO NOT release the buttons until step 5 has been completed.