2012 Subaru Legacy Owner's Manual - Page 267

Instruments and controls 3-49 NOTE Some garage door openers may require you to do the above press-holdrelease sequence a third time to complete the programming. 4. The garage door opener should now recognize the HomeLink® Wireless Control System and your garage door opener should activate when the HomeLink® button is pressed. ! Programming for entrance gates and garage door openers in Canada 1. Unplug the motor of the entrance gate or garage door opener from the outlet. 6. When the indicator light flashes slowly and then rapidly after several seconds, release both buttons. 7. Plug the motor of the entrance gate/ garage door opener to the outlet. 8. Test your entrance gate/garage door opener by pressing the programmed HomeLink® button. ! Operating the HomeLink® Wireless Control System Once programmed, the HomeLink® Wireless Control System can be used to remote-control the devices to which its buttons are programmed. To activate a device, simply press the appropriate button. The indicator light illuminates, indicating that the signal is being transmitted. ! Programming other devices To program other devices such as door locks, home lighting and security systems, contact HomeLink® at www.homelink.com or call 1-800-355-3515. ! Reprogramming a single HomeLink® button 1. Press and hold the HomeLink® button you wish to reprogram. DO NOT release the button until step 4 has been completed. 2. When the HomeLink® indicator light - CONTINUED - 1) 2) 3) HomeLink® button 1 HomeLink® button 2 HomeLink® button 3 NOTE If any of the HomeLink® buttons are already programmed for other devices, skip step 2 because it clears the memory of all three buttons. 2. Press and hold the two outer HomeLink® buttons (button 1 and button 3) until the HomeLink® indicator light begins to flash (after approximately 20 seconds). Then release both buttons. 3. Hold the end of the entrance gate's/ garage door opener's hand-held transmitter between 1 and 3 inches (25 and 76 mm) away from the HomeLink® button you wish to program. 4. Press and hold the desired HomeLink® button. 5. Press and release ("cycle") the handheld transmitter button every 2 seconds until step 6 is complete.