2012 Subaru Legacy Owner's Manual - Page 485

Maintenance and service 11-15 Model 2.5 L models 3.6 L models Oil filter color Black Blue Black Part number 15208AA100 15208AA12A 15208AA031 Amount of rotation 1 rotation 7/8 rotation 3/4 rotation CAUTION . Never over tighten the oil filter because that can result in an oil leak. . Thoroughly wipe off any engine oil that has spilled over the exhaust pipe and/or under-cover. If left unremoved, the oil could catch fire. 10. Reinstall the cover under the oil filter. 11. Pour engine oil through the filler neck. For the oil capacity (guideline), refer to "Engine oil" F12-4. The necessary quantity of oil depends on the quantity of oil that has been drained. The quantity of drained oil differs slightly depending on the temperature of the oil and the time the oil is left flowing out. After refilling the engine with oil, therefore, you must use the level gauge to confirm that the level is correct. - CONTINUED - 2.5 L non-turbo models 3.6 L models 6. Remove the oil filter with an oil filter wrench. 7. Before installing a new oil filter, apply a thin coat of engine oil to the seal. 8. Clean the rubber seal seating area of the bottom of engine and install the oil filter by hand turning. Be careful not to twist or damage the seal. 9. Tighten the oil filter by the amount indicated in the following table after the seal makes contact with the bottom of engine. 2.5 L turbo models