2012 Subaru Legacy Owner's Manual - Page 264

3-46 Instruments and controls ! Compass zone adjustment ! Compass calibration 1. If a "C" is displayed in the compass window, the compass needs to be calibrated. 2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction. 3. Your can also calibrate the compass by driving your vehicle on your everyday routine. The compass will be calibrated once it has tracked a complete circle. 4. To recalibrate your compass, push and hold the compass display button for 9 seconds until a " C " appears in the compass window. 5. Calibrate the compass according to step 2 or step 3. ! HomeLink® Wireless Control System The HomeLink® Wireless Control System can be used to activate remote control devices such as gate operators, garage door openers, door locks, home lighting and security systems. There are three HomeLink® buttons on the mirror, each of which can be programmed for operation of one desired device. For details on the device types which can be operated by this system, consult the HomeLink® website at: www.homelink.com or call 1-800-3553515. Note the following information about this system. If your vehicle is equipped with the HomeLink® Wireless Control System, it complies with Part 15 of the Federal Communications Commission Rules in the U.S. and the RSS-210 of Industry Canada in Canada. Its operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes and modifications to this system by anyone other than an authorized service facility could void authorization to use this equipment. HomeLink® and the HomeLink® house are registered trademarks of Johnson Controls, Inc. Compass calibration zones 1. Refer to the "Compass calibration zones" map shown above to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the compass display button for 3 seconds until the zone selection comes up (a number will be displayed in the mirror compass window). 3. Press the compass display button repeatedly until the correct zone setting for your location is displayed. 4. Releasing the button for 5 seconds will exit the zone setting mode. WARNING . When programming the HomeLink® Wireless Control System, you may be operating a garage door opener or other device. Make sure that people