2012 Subaru Legacy Owner's Manual - Page 327

Audio 5-45 entered. 2. Input the new passkey (a 4 - 8 digit number) by operating the "TUNE" dial. 3. Select the "CONFIRM" menu. - The new passkey is displayed, the passkey is changed and the mode changes to the Bluetooth® audio setting mode. ! Deleting device 1. Select the "DELETE AUDIO" menu. - If no devices are registered, "EMPTY" is displayed and the mode changes to the Bluetooth® audio setting mode. 2. Select the "CONFIRM" menu. - "DELETED" is displayed and the mode changes to the Bluetooth® audio setting mode. NOTE . You cannot set Bluetooth® audio while driving. . After the ignition switch is turned to the "LOCK" position, the registered device/cell phone may be automatically connected to the system if the ignition switch is turned to the "Acc" or "ON" position. . When a cell phone is already connected, the system will disconnect the phone to setup a new device. You may need to reconnect the phone after setup is complete. . Up to 2 devices (excluding cell phones for Hands-free system) can be registered. . Up to 6 devices (including cell phones for Hands-free system) can be registered. ! By using voice command system Talk switch 2. Press the talk switch . NOTE If a device and a cell phone are already registered, "BT" menu will be displayed. Then perform the following procedure. (1) Press the talk switch and say "Setup". (2) Press the talk switch again and say "Bluetooth audio setup". The "BT Audio Setup" will then be displayed. 3. After the "BT Audio Setup" menu is displayed, select the following menus by using the voice command system or by operating the "TUNE" dial. & Setting Bluetooth® audio (type C audio) 1. Press the "BT Audio" mode. button to select the NOTE If no devices are registered, you can only select from the following menu. . "Pair audio player" (refer to "Registering (paring) device" F5-46) . "Set passkey" (refer to "Selecting device" F5-46) - CONTINUED -