2012 Subaru Legacy Owner's Manual - Page 240

3-22 Instruments and controls & Select lever/gear position indicator ! Gear position indicator setting (MT models) The gear position indicator light can be activated or deactivated by performing the following procedure. 1. Turn the ignition switch to the "LOCK" position. 2. Press the trip knob to show " " or " " on the trip meter display. The display can be switched as shown in the following illustration by pressing the trip knob. NOTE . The initial setting for your vehicle of the gear position indicator has been set for activation " " at the time of shipment from the factory. . It is not possible to change the setting of the gear position indicator when the ignition switch is in the "ON" position. Change the setting when the ignition switch is in the "LOCK" or "Acc" position. & Turn signal indicator lights These lights show the operation of the turn signal or lane change signal. If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon as possible. Refer to "Replacing bulbs" F11-45. 1) Upshift/downshift indicator (AT and CVT models) This indicator shows the position of the shift lever (MT models) or select lever (AT and CVT models). ! Upshift/downshift indicator (AT and CVT models) When the manual mode is selected, the gear position indicator (which shows the current gear selection) and the upshift/ downshift indicator light up. Refer to "Selection of manual mode" F7-21. *1: " " or " " and " " or " " cannot be displayed when the ignition switch is in the "ON" position. *2: MT models only 3. To change the current setting, press the trip knob for at least 2 seconds. : Activated : Deactivated & High beam indicator light This light shows that the headlights are in the high beam mode. This indicator light also illuminates when the headlight flasher is operated.