2012 Subaru Legacy Owner's Manual - Page 332

5-50 Audio . The sound quality may degrade due to the influence of the cell phone that is connected to the system or the circumstances of the Bluetooth network. . When another Bluetooth® device is simultaneously connected, noise may be heard in the voice coming from the hands-free phone. ! Corresponding profiles for the cell phone . HFP (Hands Free Profile): Ver. 1.0 . OPP (Object Push Profile): Ver. 1.1 NOTE This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. & Certification for the Handsfree system CAUTION FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user 's authority to operate the equipment. FCC ID: ACJ932C5ZZZ035 IC ID: 216J-C5ZZZ035 Made in Japan . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. . Changes or modifications not expressly approved by the party responsible for compliance could void the user 's authority to operate the equipment. . This equipment complies with FCC/ IC radiation exposure limits set forth for an uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20 cm or more away from person's body (excluding extremities: hands, wrists, feet and ankles).