Brother International NX-450Q Users Manual - English - Page 12
Needle and presser foot, Right-side/rear view
View all Brother International NX-450Q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Needle and presser foot section Right-side/rear view a Buttonhole lever The buttonhole lever is used with the one-step buttonhole foot to create buttonholes. b Thread guide disk Pass the thread through the thread guide disk when using the needle threader to thread the needle. c Needle bar thread guide Pass the upper thread through the needle bar thread guide. d Needle plate The needle plate is marked with guides to help sew straight seams. e Needle plate cover Remove the needle plate cover to clean the bobbin case and race. f Bobbin cover Open the bobbin cover to set the bobbin. g Feed dogs The feed dogs feed the fabric in the sewing direction. h Presser foot The presser foot applies pressure consistently on the fabric as sewing takes place. Attach the appropriate presser foot for the selected stitch. i Presser foot holder The presser foot is attached onto the presser foot holder. a Presser foot dial Use the presser foot dial to adjust the amount of pressure that the presser foot applies to the fabric. b Handle Carry the sewing machine by its handle when transporting the machine. c Handwheel Turn the handwheel toward you to raise and lower the needle. The handwheel should be turned towards you (counterclockwise). d Air vent The air vent allows the air surrounding the motor to circulate. Do not cover the air vent while the sewing machine is being used. e Main power switch Use the main power switch to turn the sewing machine ON and OFF. f Foot controller jack Insert the plug on the end of the foot controller cable into the foot controller jack. g Power supply jack Insert the plug on the power cord into the power supply jack. h Feed dog position switch Use the feed dog position switch to lower the feed dogs. i Presser foot lever Raise and lower the presser foot lever to raise and lower the presser foot. Memo z Refer to pages 9 through 12 while you are learning to use your machine. Names of Machine Parts and Their Functions 11