Brother International NX-450Q Users Manual - English - Page 37
Pulling up the bobbin thread - quilting
View all Brother International NX-450Q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
GETTING READY Pulling up the bobbin thread When making gathers or before free-motion quilting, first pull up the bobbin thread as described below. Insert the bobbin into the bobbin case. a • Refer to steps a through e of "Installing the bobbin" (page 26). Pull out about 10-15 cm (4-5 inches) of the e bobbin thread under the presser foot toward the rear of the machine. Pass the bobbin thread through the slot. b Do not cut the thread with the cutter. While lightly holding the upper thread with c your left hand with the needle in the up- position, press ("Needle Position" button) twice to lower and raise the needle. Reattach the bobbin cover. f Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side. 2 1 1 a "Needle Position" button X The bobbin thread is looped around the upper thread and can be pulled up. Carefully pull the upper thread upward to pull d out the end of the bobbin thread. 36