Canon CR-N500 Remote Camera Settings Guide - Page 29

[Auto (sec.)] Automatically adjusts the shutter speed according to the brightness of the video. [Speed (sec.)] Sets the shutter speed to seconds. The shutter speed can also be set to a value higher than the frame rate. [Slow (sec.)] Sets the shutter speed slower than the frame rate to seconds. This setting is used for shooting in low-light areas. Also, special effects such as "blurring the background" and "adding residual image effects to zoom" are available for shooting a moving subject with pan operation. For precautions when shooting in slow, refer to "About Shooting with Slow Shutter" (P. 30). [Clear Scan (Hz)] Sets the shutter speed by frequency. This is used to reduce black bands on the screen, flickering from fluorescent lighting, and to fine tune the brightness. The shutter speed that can be selected differs depending on the frame frequency. Shutter Mode Auto (sec.) Speed (sec.) Slow (sec.) N500 23.98 1/24 - 1/2000 1/24 - 1/2000 1/3, 1/6, 1/12 N300 1/6, 1/12 Clear Scan (Hz) 23.98 - 250.38 29.97 1/30 - 1/2000 1/30 - 1/2000 1/4, 1/8, 1/15 1/8, 1/15 29.97 - 250.38 Frame Frequency (Hz) 59.94 25.00 1/60 - 1/2000 1/25 - 1/2000 1/60 - 1/2000 1/25 - 1/2000 1/4, 1/8, 1/15, 1/30 1/3, 1/6, 1/12 1/8, 1/15, 1/30 1/6, 1/12 59.94 - 250.38 25.00 - 250.40 50.00 1/50 - 1/2000 1/50 - 1/2000 1/3, 1/6, 1/12, 1/25 1/6, 1/12, 1/25 50.00 - 250.40 Note • When the [Shooting Mode] is set to (Shutter Priority AE), the shutter speed value can be set as follows according to the frame frequency. N300 - At 23.98, 25.00, or 50.00 Hz: 1/6 to 1/2000 sec. - At 29.97 or 59.94 Hz: 1/8 to 1/2000 sec. [Gain (dB)] Able to set the amplification amount of the video amplifier. When [Auto] is set, the gain is automatically adjusted. By setting the [AGC Limit], the maximum gain can be limited. When [Auto] is off, the gain can be manually adjusted. Adjustment can be made in the ranges below. N500 -6.0 to 33.0 dB (by 0.5) N300 0.0 to 36.0 dB (by 0.5) When [Image Quality] > [Gamma] is [Wide DR] or [Canon Log3], the adjustment range is 2.5 to 33.0 dB. N500 Note Increasing the gain may cause a slightly grainy screen. Also, uneven colors, white dots, and vertical lines may appear on the screen. [AGC Limit] Able to suppress the occurrence of grainy screen, uneven colors, white dots, vertical lines, etc. by limiting the maximum value when the gain is set to [Auto]. Adjustment can be made in the ranges below. N500 -6.0 to 33.0 dB (by 0.5) N300 0.0 to 36.0 dB (by 0.5) When [Image Quality] > [Gamma] is [Wide DR] or [Canon Log3], the adjustment range is 2.5 to 33.0 dB. N500 Note When the shooting mode is N500 Maximum 33.0 dB N300 Maximum 24.0 dB (Full Auto), the [AGC Limit] value will not be applied. It will be limited by the maximum values below. [AE Shift] When one of the [Iris (Aperture Value)], [Shutter Mode] or [Gain (dB)] is set to auto, the exposure can intentionally be compensated to capture subjects either at a brighter or darker exposure. 29