Canon CR-N500 Remote Camera Settings Guide - Page 66

[System] > [Communication] > [External Connection (Serial)] Settings for communication by the serial connection of controllers, etc. Note Connect the Remote Camera Controller RC-IP100 via IP. This camera cannot be controlled by the serial connection. Serial Port Detail settings for the serial port. [Serial Port] Select whether to use the serial port. [Serial Port Connection Type] RS-422 as fixed value. [Baud Rate (bps)] Select the Baud Rate value. [Data Length (bit)] Data length of serial communication is fixed at 8 bit. [Start Bit (bit)] The length of the start bit is fixed at 1 bit. [Stop Bit (bit)] The length of the stop bit is fixed at 1 bit. [Parity] The settings for the error detection code is fixed to None Note In the next item, if the [Standard Communication (Serial)] is set as [Enable], the settings for the baud rate of the serial communication, data length, stop bit, and parity will be changed as follows. - Baud rate : Speed of Standard Communication (Serial) - Data length (bit) : 8 - Stop bit (bit) : 1 - Parity : None 66