Casio QT 6600 Reference Manual - Page 40

Application System 2-3-2. Remote printer control setting Remote printer settings: After changing the DIP switch configuration, remote printer initialization (power on by pressing the key) is necessary. UP-400 Dip switch is located at the bottom of the printer. SW No. Function ON OFF 1 Reset by DTR Yes No 2 reserved --- fixed 3 Protocol DTR/DSR XON/XOFF 4 Transmision speed 15 6 Parity 7 See transmission speed setting See paritysetting 8 Busy status BF full + offline BF full 9 Low power comsumption Yes No 10 3mm feed after auto-cut Invalid Valid SW No. Function 1 Data reception error 2 Bit length 3 Reception buffer full 2 4 Set ID/ set IP 5 Use DHCP server 6 Set default value 7 Undefined 8 Undefined ON Ignore 7 bit *1 Set IP Enable Yes OFF Print "?" 8 bit *2 Set ID Disable No Switch 1 Switch 2 UP-400 Bottom view Transmission speed setting Parity setting SW No. bps 4 5 4800 OFF OFF 9600 OFF ON 19200 ON OFF 38400 ON ON Non Even Odd Non SW No. 67 OFF OFF OFF ON ON OFF ON ON *1 Until the non-processing data in the reception buffer decreases from 31 bytes to 21 bytes *2 Until the room of the reception buffer increases from 1k bytes to 2k bytes Shadowed parts indicate defaults. UP-360 Dip switch is located at the bottom of the printer. SW No. Function 1 Reset by DTR 2 reserved 3 Protocol 1 4 Transmision speed 5 6 Parity 7 8 undifined 9 Low power comsumption 10 undifined ON OFF Yes No --- fixed DTR/DSR XON/XOFF See transmission speed setting See paritysetting --- --- Yes No --- --- UP-360 Bottom view Transmission speed setting Parity setting SW No. bps 4 5 4800 OFF OFF 9600 OFF ON 19200 ON OFF 38400 ON ON Non Even Odd Non SW No. 67 OFF OFF OFF ON ON OFF ON ON R-40