Cisco AP541N-A-K9 Administration Guide - Page 13
Connecting the Access Point to the PC through a Network Connection, Getting Started, - poe
View all Cisco AP541N-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Getting Started Connecting the Access Point to a PC 1 Connecting the Access Point to the PC through a Network Connection To connect the access point to an administration PC through the network: STEP 1 Connect one end of an Ethernet straight-through or crossover cable to the network port on the access point, as shown in Figure 2. STEP 2 Connect the other end to the same hub or switch where your PC is connected. Figure 2 Connecting the Access Point Using a LAN Connection The hub or switch you use must permit broadcast signals from the access point to reach the other devices on the network. STEP 3 If you are not using PoE, connect the power adapter to the power port on the back of the access point, then plug the other end of the power cord into a power outlet. Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide 10