Cisco AP541N-A-K9 Administration Guide - Page 167
WDS Configuration Using SNMP, STEP 1
View all Cisco AP541N-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
Configuration Examples Configuring the Wireless Distribution System 8 NOTE MyAP1 and MyAP2 must be set to the same IEEE 802.11 Mode and be transmitting on the same channel. WDS Configuration Using SNMP STEP 1 Load the FASTPATH-WLAN-ACCESS-POINT-MIB module. STEP 2 From the MIB tree, navigate to the objects in the apIfConfig table. STEP 3 Walk the apIfConfigName object to view the instance ID for the first WDS link (wlan0wds0). The first WDS link is instance 1. STEP 4 Set the value of instance 1 in the apIfConfigRemoteMac object to 00:30:AB:00:00:B0. In the MG-Soft browser, the format for the MAC address value to set is # 0x00 0x30 0xAB 0x00 0x00 0xB0. STEP 5 Set the value of instance 1 in the apIfConfigWdsSecPolicy object to WPA Personal (3). STEP 6 Set the value of instance 1 in the apIfConfigSsid object to wds-link. STEP 7 Set the value of instance 1 in the apIfConfigWdsWpaPskKey object to abcdefthijk. Some MIB browsers require that the value be entered in HEX values rather than ASCII values. STEP 8 Perform the same configuration steps on MyAP2. Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide 164