Cisco CISCO776 Installation Guide - Page 107
Configuration Requirements for Lucent5ESS Custom Switch, Point-to-Point Configuration
![]() |
View all Cisco CISCO776 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Table C-7 NI1 Configuration Parameter Router software Configuration U.S. version Software Command -1 Switch type SPIDs NI1 At least one required2 set switch set spid Directory number At least one required set directory number 1 This parameter is not set with a software command. 2 The Cisco 765, Cisco 766, Cisco 775, and Cisco 776 require two SPIDs so that the basic telephone service ports (POTS) operate correctly. Configuration Requirements for Lucent 5ESS Custom Switch This section describes the router configuration requirements when using Cisco 700 series routers with an Lucent 5ESS Custom switch. Point-to-Point Configuration Table C-8 lists the router configuration requirements when using an Lucent 5ESS Custom switch in a point-to-point configuration. Table C-8 Lucent 5ESS Custom Point-to-Point Configuration Parameter Router software Configuration U.S. version Software Command -1 Switch type SPIDs 5ESS None required set switch -2 Directory number Optional set directory number 1 This parameter is not set with a software command. 2 This parameter is not set when SPIDs are not used because it might cause unpredictable results. Provisioning the ISDN BRI Line C-11
![](/manual_guide/products/cisco-776m-installation-guide-780c93a/107.png)