Cisco CISCO776 Installation Guide - Page 52
Connecting an ISDN Digital Telephone, Step 1
View all Cisco CISCO776 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Connecting an ISDN (Digital) Telephone You must provide the following equipment: • NT1 with two S/T interfaces and one U interface. • Telephone cable to connect digital telephone. (This cable is usually provided with the telephone.) • ISDN U cable that connects the NT1 to the ISDN wall jack. Take the following steps to connect the ISDN telephone and external power supply. This procedure assumes you have connected the ISDN U port to the ISDN wall jack (see Figure 4-1). Step 1 Connect an RJ-45-to-RJ-45 cable (included) from the ISDN S/T port (on the rear panel of the router) to the port labeled LINE on the ISDN telephone power supply. (See Figure 4-2.) Step 2 Connect the ISDN telephone RJ-45 cable to the port labeled PHONE on the ISDN telephone power supply. (See Figure 4-2.) Step 3 Connect the telephone power supply to the power outlet. You can now use the ISDN telephone on the same ISDN line as the router. 4-4 Cisco 700 Series Router Installation Guide