Cisco CISCO776 Installation Guide - Page 92
Return, Transfer, Send text file, Downloading Software, Step 3
![]() |
View all Cisco CISCO776 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Downloading Software Step 3 Enter y to continue: Are you sure? y You are prompted to select the baud rate. BOOT version 2.0(1) 04-16-96 12:03:06 Copyright (c) 1993-1996. All rights reserved. Ready to upload new firmware into flash. Select baud rate: 1 - 300 baud 2 - 1200 baud 3 - 2400 baud 4 - 4800 baud 5 - 9600 baud 6 - 19200 baud 7 - 38400 baud 8 - 57600 baud 9 - 115200 baud Step 4 Enter 5. Note Hyperterminal does not allow you to change baud rate on-the-fly; however, if you are using another terminal emulation software, you might be able to do so to increase the speed of the download. To change the baud rate, enter the number that corresponds to the desired baud rate. Do not press the Return key. Set the baud rate on the terminal to match the selected baud rate. Set the protocol to ASCII on the terminal. Press Return. Download the file containing the new software to the router by following the prompts on your terminal. Step 5 Select Transfer>Send text file. The system loads the file on the router. (The LINE LED blinks throughout the loading process.) When the download is complete, the LINE LED turns off, and the RDY LED turns on. B-6 Cisco 700 Series Router Installation Guide
![](/manual_guide/products/cisco-776m-installation-guide-780c93a/92.png)