Cisco CISCO776 Installation Guide - Page 38
See Connecting Ethernet Devices, Step 1
View all Cisco CISCO776 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Connecting Ethernet Devices To connect Ethernet devices to the router, complete the following steps: Step 1 If you are connecting to a node, or if you are connecting a Cisco 761, Cisco 762, Cisco 765, Cisco 771, Cisco 772, or Cisco 775 router to a hub, connect the yellow Ethernet cable to the yellow port labeled ETHERNET on the rear panel. If you are connecting a Cisco 766 or Cisco 776 router to a hub, connect an Ethernet crossover cable (not supplied) to any open Ethernet port. Step 2 Connect the other end of the cable to the Ethernet connector on the LAN device, such as the Ethernet port of the NIC on the back of your computer. (See Figure 3-1.) Step 3 Set the HUB/NODE switch if you are connecting a Cisco 700 series router other than a Cisco 766 or Cisco 776 router. (a) If your router is connected to another device, such as a NIC in a PC, set the switch in HUB position. (b) If your router is connected to an Ethernet hub, set the switch in NODE position. (Cisco 766 or Cisco 776 routers do not have a HUB/NODE switch.) 3-2 Cisco 700 Series Router Installation Guide