Cub Cadet ZT1 42 FAB Operation Manual - Page 12
Adjusting the Seat
View all Cub Cadet ZT1 42 FAB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ASSEMBLY CHARGING THE BATTERY Test and, if necessary, recharge the battery after the tractor has been stored for a period of time. Models with Lead-Acid Battery • A voltmeter or load tester reading of 12.4 volts (DC) or lower across the battery terminals indicates that the battery needs to be charged. • A lead-acid battery charger should be used. Recommended charge rate is 4A/14.7V. • If your battery charger is automatic, charge the battery until the charger indicates that charging is complete. If the charger is not automatic, charge for no fewer than eight (8) hours. Models with AGM Battery • An AGM battery charger should be used. Recommended charge rate is 1.1A/14.8V. IMPORTANT! Do NOT use an automotive charger. • If your battery charger is automatic, charge the battery until the charger indicates that charging is complete. If the charger is not automatic, charge for no fewer than eight (8) hours. Adjusting the Seat LEVER ADJUST 1. Push left and hold the seat adjustment lever to adjust the seat position. 2. Slide seat forward or rearward to desired position. 3. Release the adjustment lever. Ensure seat is locked into position before operation. See Figure 17. KNOB ADJUST 1. Remove the knobs (a). See Figure 16. 2. Slide the seat up or down into the desired position. 3. Replace the knobs into one of the four hole settings and tighten securely. See Figure 16. Figure 17 (a) (a) Figure 16 12