Dell FC4500 Reference Guide - Page 85
Removing a PowerSupply Filler Module
View all Dell FC4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Servicing and Upgrading a DPE 3 Removing a Power-Supply Filler Module If one power supply is off and the other is on, do not turn one on and immediately turn off the other. Instead, turn one on and wait five seconds before turning the other off. If you are adding a new power supply, remove the power-supply filler module as shown next. If you are replacing a faulty power supply, remove the power-supply module itself as follows. 1. Remove the drive fan pack as shown on page 3-35. 2. Remove the filler module as shown in Figures 3-26 and 3-27. Bottom filler module Latch (one per side) A. Push each latch of the filler module toward the center. Figure 3-26 Removing the Bottom Filler Module B. Pull the filler module from its slot. Replacing or Adding a Power-Supply Module 3-37