Dell Latitude E6400 XFR Service Manual - Page 13

Battery Problems, Drive Problems - noise

Get Dell Latitude E6400 XFR PDF manuals and user guides View all Dell Latitude E6400 XFR manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Dell™ Latitude™ E6400 XFR Service Manual 1.2.1 Battery Problems CAUTION: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. 1.2.2 Drive Problems CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. ENSURE THAT MICROSOFT WINDOWS RECOGNIZES THE DRIVE - Windows XP:  Click Start and click My Computer. Windows Vista:  Click the Windows Vista Start button and click Computer. If the drive is not listed, perform a full scan with your antivirus software to check for and remove viruses. Viruses can sometimes prevent Windows from recognizing the drive. TEST THE DRIVE -  Insert another disc to eliminate the possibility that the original drive is defective.  Insert a bootable floppy disk and restart the computer. CLEAN THE DRIVE OR DISK - For information on cleaning your computer, see the Dell™ Technology Guide on your computer or at support.dell.com. CHECK THE CABLE CONNECTIONS RUN THE HARDWARE TROUBLESHOOTER - See Hardware Troubleshooter. RUN THE DELL DIAGNOSTICS - See Dell Diagnostics. Optical Drive Problems NOTE: High-speed optical drive vibration is normal and may cause noise, which does not indicate a defect in the drive or the media. NOTE: Because of different regions worldwide and different disc formats, not all DVD titles work in all DVD drives. ADJUST THE WINDOWS VOLUME CONTROL -  Click the speaker icon in the lower-right corner of your screen.  Ensure that the volume is turned up by clicking the slidebar and dragging it up.  Ensure that the sound is not muted by clicking any boxes that are checked. CHECK THE SPEAKERS AND SUBWOOFER - See Sound and Speaker Problems. Problems writing to an optical drive CLOSE OTHER PROGRAMS - The optical drive must receive a steady stream of data during the writing process. If the stream is interrupted, an error occurs. Try closing all programs before you write to the optical. TURN OFF STANDBY MODE IN WINDOWS BEFORE WRITING TO A DISC - For information about setting power options, see the Dell™ Technology Guide on your computer or at support.dell.com. You can also search for the keyword standby in Windows Help and Support for information on power management modes. Page 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
Dell
™
Latitude™ E6400 XFR Service Manual
Page 13
1.2.1
Battery Problems
CAUTION:
There is a danger of a new battery exploding if it is incorrectly installed.
Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.
1.2.2
Drive Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
ENSURE THAT MICROSOFT WINDOWS RECOGNIZES THE DRIVE —
Windows XP
:
Click
Start
and click
My Computer
.
Windows Vista
:
Click the Windows Vista Start button
and click
Computer
.
If the drive is not listed, perform a full scan with your antivirus software to check for and remove viruses. Viruses can
sometimes prevent Windows from recognizing the drive.
TEST THE DRIVE —
Insert another disc to eliminate the possibility that the original drive is defective.
Insert a bootable floppy disk and restart the computer.
CLEAN THE DRIVE OR DISK —
For information on cleaning your computer, see the
Dell™ Technology Guide
on your
computer or at
support.dell.com
.
CHECK THE CABLE CONNECTIONS
RUN THE HARDWARE TROUBLESHOOTER —
See Hardware Troubleshooter
.
RUN THE DELL DIAGNOSTICS —
See Dell Diagnostics
.
Optical Drive Problems
NOTE:
High-speed optical drive vibration is normal and may cause noise, which does not indicate
a defect in the drive or the media.
NOTE:
Because of different regions worldwide and different disc formats, not all DVD titles work
in all DVD drives.
ADJUST THE WINDOWS VOLUME CONTROL —
Click the speaker icon in the lower-right corner of your screen.
Ensure that the volume is turned up by clicking the slidebar and dragging it up.
Ensure that the sound is not muted by clicking any boxes that are checked.
CHECK THE SPEAKERS AND SUBWOOFER —
See Sound and Speaker Problems
.
Problems writing to an optical drive
CLOSE OTHER PROGRAMS —
The optical drive must receive a steady stream of data during the writing process. If
the stream is interrupted, an error occurs. Try closing all programs before you write to the optical.
TURN OFF STANDBY MODE IN WINDOWS BEFORE WRITING TO A DISC —
For information about setting power
options, see the
Dell™ Technology Guide
on your computer or at
support.dell.com
. You can also search for the
keyword
standby
in Windows Help and Support for information on power management modes.