Dell Latitude E6400 XFR Service Manual - Page 28
Replacing a WPAN UWB/BT Card, Removing a FCM from the WWAN/FCM Slot
View all Dell Latitude E6400 XFR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Dell™ Latitude™ E6400 XFR Service Manual 7.2 Replacing a WPAN (UWB/BT) Card NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and realign the card. NOTICE: To avoid damage to the WPAN card, ensure the cables are not under the card when you replace it. NOTICE: Insert a WPAN card only into the slot labeled WPAN/UWB/FCM. 1. Slide the card into the connector labeled WPAN/UWB/FCM. NOTE: The insertion of the card is considered a blind insert since the connector is not visible. Please take proper precautions during assembly to verify connection is set before securing the card. 2. Press the card down and hold it in place. 3. Replace the M2 x 3-mm screw. 4. Connect the blue antenna cable to the WPAN card. 5. Replace the Bottom Access Panel (see Replacing the Bottom Access Panel). 6. Follow the procedures in After Working on Your Computer. 8 FCM CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. The FCM is also known as Intel® Turbo Memory and the Intel Flash Cache Logic Chip Mini-card. You can install an FCM in either the WWAN/FCM card connector or the WPAN/UWB/FCM card connector. NOTE: This module is only compatible with the Microsoft® Windows Vista® operating system. 8.1 Removing a FCM from the WWAN/FCM Slot 1. Follow the procedures in Before Working on Your Computer. 2. Remove the bottom access panel (see Removing the Bottom Access Panel). 3. Remove the M2 x 3-mm screw. The FCM pops up at a 45-degree angle. 4. Slide the FCM out of the card connector on the system board. Page 28