Dell Latitude E6400 XFR Service Manual - Page 55
Remove the gasket from the multi-mode display port. - e port
View all Dell Latitude E6400 XFR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Dell™ Latitude™ E6400 XFR Service Manual 1 3 2 1 M2.5 x 5-mm screws (8) 2 M2 x 3-mm screws (2) 3 1394 connector NOTE: Smartcard assembly removed to clarify screw locations and pinpoint system board connectors. The smartcard assembly should not be removed for system board or base assembly replacement. 15. Lift the back-right corner of the base assembly to release the I/O board connector. Gently lift the right side of board up while lifting the gasket at the multi-mode display port. 16. Remove the gasket from the multi-mode display port. 17. Slide the system board to the right to disengage it from the chassis. 18. Disconnect the DC cable, which is connected to the bottom of the system board. 19. Lift the system board out of the base assembly. 20. Remove the card cage (see Removing the Card Cage). 2 7 Page 55 1 3 4 5 6