Dell PowerEdge M610x Fabric OS Command Reference Manual Supporting Fabric - Page 380
Fabric Watch thresholds., snmp, raslog. Note
View all Dell PowerEdge M610x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 380 highlights
2 fmConfig -port port_list Specifies one or more ports on which to install the monitor for the specified frame type. This operand is optional; if omitted, the monitor is installed on all eligible ports. A port list can consist of the following: • One or more single ports, preceded by a slot number followed by a slash (/) on bladed systems. Multiple ports must be separated by a comma, for example, 8 or 5/8 or 3,5,8. • One or more port ranges where the beginning and end port are separated by a dash, for example, 8-13 or 5/8-13, or 3/4-9. A port range cannot span multiple slots. -nosave Overrides the default behavior of fmConfig --create, which automatically saves the configuration and collected data persistently. When -nosave is specified, the configuration is nonpersistent and will be erased upon reboot. -nosave resembles the behavior of the legacy filter monitor commands. This operand is optional and valid only with the --create, --addmonitor and --delmonitor options. It is not valid with the --change option. -highth value Sets the high threshold value for the specified frame monitor. This operand is optional. High threshold values and defaults are platform-specific. Refer to the Fabric Watch Administrator's Guide for more information. -timebase time_base Specifies the time interval between two samples to be compared. Valid intervals are: day Samples are compared once a day. hour Samples are compared once every hour. minute Samples are compared once every minute. second -action value Samples are compared once every second. Specifies the action triggered if the frame count for the specified frame type exceeds the configured high threshold. Valid actions include snmp, raslog, portlog, email or none. This operand is optional; if omitted, defaults are used (snmp, raslog). Note that fmConfig only supports specification of high thresholds and the actions taken when the frame count exceeds the configured high threshold. Use the thConfig command with the filter class operand to configure and display other Fabric Watch thresholds, and the actions to be taken when the counters fall below or in-between configured Fabric Watch thresholds. -force Enables the Frame Monitor feature without confirmation. This operand is used only once with options that implicitly enable the new feature and disable the legacy commands. These options include --create, --addmonitor, --delmonitor, and --show. When executed without -force, these commands prompt for confirmation. --save frame_type Saves the set of ports on which the specified frame type is monitored to the persistent configuration. If a frame type is not specified, this command saves the port configurations of all existing frame types. This operation removes the configuration for ports not monitored. 348 Fabric OS Command Reference 53-1001764-02