Dell PowerEdge M610x Fabric OS Command Reference Manual Supporting Fabric - Page 454

2 ipAddrSet -ipv6 [-auto | -noauto] Enables or disables stateless IPv6 autoconfiguration on a switch or chassis. When autoconfiguration is enabled, the host automatically performs configuration of IPv6 addresses and periodic nondisruptive reconfiguration. By default, autoconfiguration is disabled. -ls FID Specifies the logical fabric ID for which to configure an IPFC network interface. The FID is a decimal number. A switch that is not in Virtual Fabric mode uses the -ls parameter with FID 128 (the effective, single Logical Fabric number on such switches) to set the IPv4 FC address. Note that setting the IP address for the logical switch is only for the IPFC interface, not for the Ethernet interface. --add Assigns a specified IPv4 FC address and prefix to the logical switch instance represented by the specified FID. This command replaces any existing FC IPv4 address. IPv4_address/prefix Specifies the IPv4 address and prefix for the IPFC network interface. The IP Address is represented by a dotted decimal number, followed by a slash and a prefix. This operand is required with the --add option. --delete -ls IFID Deletes the IPv4 FC address and prefix from a logical switch. Specifies the fabric ID that identifies the logical switch for which to delete the FC IPv4 address and prefix. This operand is required when deleting an FC IPv4 address from a logical switch. On a switch that is not in Virtual Fabric mode, use the -ls parameter with FID 128 (the effective, single Logical Fabric number on such switches) to delete the IPv4 FC address. When used interactively to configure IPv4 addresses on a modular platform, ipAddrSet prompts for the following parameters: -cp cp_number Specifies the managed entity as a CP. Valid values are: 0 Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address, and host name of CP0. 1 Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address, and host name of CP1. -chassis Specifies the managed entity as the chassis. Examples Command line examples To configure an IPv6 address and prefix on a standalone platform: switch:admin> ipaddrset -ipv6 --add fec0:60:69bc:60:260:69ff:fed0:107/64 To configure an IPv6 address and prefix on a single CP of a chassis: switch:admin> ipaddrset -cp 0 -ipv6 --add 1080::8:800:200C:417A/64 To delete any existing IPv6 address and prefix on CP0 on an enterprise-class platform: switch:admin> ipaddrset cp 0 -ipv6 --delete To configure a local IPv4 Ethernet address on a Brocade FC4-16E in a chassis (prefix required): switch:admin> ipaddrset -slot 1 -eth0 --add 10.12.34.123/24 To configure a local IPv4 Ethernet address on an AP7600 with a hidden BP: 422 Fabric OS Command Reference 53-1001764-02