Dell PowerEdge M610x Fabric OS Command Reference Manual Supporting Fabric - Page 457
ipAddrShow, Dynamic Host Control Protocol DHCP: on or Off
View all Dell PowerEdge M610x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 457 highlights
ipAddrShow 2 ipAddrShow Displays IP address information for a switch or control processor (CP). Synopsis ipaddrshow ipaddrshow [-cp cp_number] | -chassis ipaddrshow -slot slot_numb [-eth0 | -eth1 | -gate] Description Use this command to display the IP addresses configured in the system. The -cp option displays the IP address for a specified CP on modular platforms, or use the command without arguments to display the IP address on a standalone switch, or the IP addresses for both CPs on a chassis. On a standalone switch, the command displays the following information: • Ethernet IP Address • Ethernet Subnet mask • The Gateway IP Address • Dynamic Host Control Protocol (DHCP): on or Off • Pv6 Autoconfiguration Enabled: Yes or No • Local IPv6 Addresses On modular platforms, the command displays the following information: For the chassis: • Ethernet IP Address • Ethernet Subnet mask For each CP: • Ethernet IP Address • Ethernet Subnet mask • Host Name • Gateway IP Address If the IPFC network interface is configured for logical switches: • IPFC address for Virtual Fabric ID For each CP: - Backplane IP address - IPv6 Autoconfiguration Enabled: Yes or No If enabled, the command displays: • All local IPv6 Addresses • Gateway IP addresses for both CPs Local IPv6 addresses display the following identifiers: IP Address type: • static - A statically configured IPv6 address. Fabric OS Command Reference 425 53-1001764-02