Dell PowerEdge M610x Fabric OS Command Reference Manual Supporting Fabric - Page 938
supportFtp, Specifies the remote directory where the trace dump files are stored.
View all Dell PowerEdge M610x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 938 highlights
2 supportFtp supportFtp Sets, clears, or displays support FTP parameters and enables or disables auto file transfer. Synopsis supportftp [-S] supportftp -s [-h host][-u username][-p password][-d remotedirectory] supportftp -t hours supportftp -R supportftp -e supportftp -d Description Use this command to set, clear, or display support FTP parameters. The parameters set by this command are used by the supportSave and traceDump commands. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following mutually exclusive operands: -S Displays the current FTP parameters. -s Sets the FTP parameters. The following operands can be optionally specified on the command line. If the -s option is specified without further operands, the command interactively prompts for these parameters. -h host Specifies the FTP host. Provide an IP address or a server name. IPv4 and IPv6 addresses are supported. To specify the host by name, a DNS entry must exist for the server. -u username Specifies the FTP account user name. The user name must be less than 48 characters long. -p password Specifies the FTP account password. The password must be less than 48 characters long. When using anonymous FTP, a password is not required. -d remotedirectory -t hours Specifies the remote directory where the trace dump files are stored. The directory name must be less than 48 characters long. Specifying the root directory as the remote directory (/) is not allowed. Specifies the time interval, in units of hours, at which the FTP server connectivity is checked. -R Clears all FTP parameters. -e Enables auto file transfer. Trace dump files are automatically transferred to a designated FTP server. The server parameters must be set before you can enable auto file transfer. -d Disables auto file transfer. 906 Fabric OS Command Reference 53-1001764-02