Dell PowerEdge M610x Fabric OS Command Reference Manual Supporting Fabric - Page 857

secAuthCertificate 2 secAuthCertificate Configures FCAP certificate for authentication with peer switches Synopsis secauthcertificate --show secauthcertificate --set [-wwn wwn | -did domain_id |-all] [ -usecert brcd | thirdparty] secauthcertificate --remove [-wwn wwn | -did domain_id |-all] secauthcertificate --help Description Use this command to manage certificates for FCAP authentication on a switch. FCAP requires the exchange of certificates between two or more switches to authenticate each other before they are allowed to join fabric. FCAP certificates can be issued by Brocade or any third party CA. Use this command to add, remove, or display the switches in the certificate database. When adding switches, you can specify the type of certificate to be used in the authentication. Brocade and third Party certificates are supported. Fabric OS supports two authentication protocols, DHCHAP and FCAP. By default, FCAP is the default switch authentication protocol. Use the authUtil command to configure the authentication protocol. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: --show Displays the switches in the certificate database. No operand is required with this command. --set Adds the specified switch entries to the certificate database. --remove Removes the specified switch entries from the certificate database. --help Displays the command usage. One or more switches must be specified with the --set and --remove options. The switches can be specified in one of the following ways; each of these operands is inclusive: -wwn wwn Specifies the World Wide Name of the peer switches. You may specify multiple WWNs separated by a comma.. -did domain_id Specifies the Domain ID of the peer switches. You may specify multiple DIDs separated by a comma. -all Specifies all switches in the fabric. -usecert brcd | thirdparty Specifies the FCAP certificate to be used for authentication with the specified switches. Specify thirdparty to use a third party certificate. Specify brcd to use a Brocade certificates (default). This operand is optional with the --set option; if omitted, the default is used. Fabric OS Command Reference 825 53-1001764-02