Dell PowerEdge R910 Hardware Owner's Manual - Page 106
Removing the Memory-Riser Guide, If applicable, remove the memory-riser blanks. See Removing a Memory
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
5 Press down and out on the ejectors on each end of the socket until the memory module pops out of the socket. See Figure 3-9. 6 Close the memory module cover. 7 Install the memory risers. See "Installing a Memory Riser" on page 101. 8 Close the system. See "Closing the System" on page 90. 9 Reconnect the system and peripherals to their power sources, and turn them on. Removing the Memory-Riser Guide 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 89. 3 If applicable, remove the memory-riser blanks. See "Removing a Memory- Riser Blank" on page 99. 4 Remove the memory risers. See "Removing a Memory Riser" on page 100. 5 Press the tabs in the direction of the arrows and lift the memory-riser guide out of the system. Figure 3-10. Removing or Installing the Memory-Riser Guide 1 2 1 memory-riser guide 2 tabs (2) 106 Installing System Components